Shopping Cart0 item(s) in cart/ Total: $0
JRR Mitsubishi EVO X Firmware
JRR Mitsubishi EVO X Firmware

JRR Mitsubishi EVO X Firmware

Your Price Each: $0.00
MoTeC Dealer Item Only
Part Number:JRR Mitsubishi EVO X Firmware
***FOR MORE INFO OR TO PURCHASE THIS PACKAGE, PLEASE VISIT THE DEALERS WEBSITE***


JRR Mitsubishi Evolution X firmware license for MoTeC M1 ECU

If you are a MoTeC dealer or already own an M1 ECU, you can purchase just the firmware license - no ECU purchase required 

This firmware package suits 2008-2016 Mitsubishi Evo X

May support other Mitsubishi models which feature the 4B11 engine and the same CAN protocols
Targeted package specific to one engine saves money versus buying GPR

Available for the M130 and M150 ECU. M170 and M190 version available by special order

A paddle shift gearbox control version of this firmware is also available - based on MoTeC GPR-P
This firmware is based upon MoTeC GPR package and includes the following features:

Includes full ACD control - control the center differential system directly from the M1 ECU (some wiring required)

Full integration with Mitsubishi Evo X OE CAN bus - maintains proper vehicle operation and dash functionality

Supports the factory cruise control including the steering wheel controls

Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content

Supports running two separate fuel systems - each running a different type of fuel

Nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure

CO2/wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure

Water injection control - with failsafe for boost/timing/fuel based on pressure sensor feedback

Air bypass anti-lag control - for increased ALS performance (when used with appropriate engine hardware)

Boost control system allows incorporating turbo shaft speed and turbo compressor inlet pressure into the control strategy

Supports the use of third party lambda controllers with 0-5v output

Supports momentary buttons

Supports direct input from a MoTeC/Racegrade CAN keypad

Recently Viewed Items